MLS-200 is the EoDSL(Ethernet over DSL Network) bridge that efficiently extends 10/100 Ethernet circuits to 2 wire-Networking LAN for Internet and Intranet access. Over 915 meters (3,000feet) at 50Mbps using existing phone wire. This modem will allow Ethernet connectivity in existing facilities without pulling extra cable. This is perfect solution to Ethernet on the factory floor where systems have been upgraded from slower serial communication to Ethernet networking. Installation is easy with a single switch setting. One end is set for local and the other remote. This modem is used in phone wire to extend Ethernet connectivity over existing phone grade phone wire.
l High-Speed 100/95Mbps communications link over existing phone line cable, Asymmetrical on EoDSL
l [email protected]
915 meters (3,000feet), reach down to 20Mbps @ about 1.7Km(5,600feet)
l Operates transparent to high layer protocols such as TCP/IP
l Auto-MDIX and Auto-sensing 10Base-T or 100Base-TX and Full or Half-Duplex on the Ethernet port
l Plug and Play design for simple installation, single DIP switch for configuration.
l Status LEDs for simple monitoring of the device and connection status
l Extend LAN connectivity to a remote site or between buildings
l Connect Ethernet over the different Room over existing house’s phone line infrastructure
l Connect new controller technology on the factory floor using existing wiring
l Extend Ethernet connectivity from a backbone network to an isolated location via copper wire
l Transmit Video and traffic controller information over existing copper wire
n FCC part 15 Class B, CE Mark